Strain gauge PFT 100 kg (Special developments)
PFT sensors allow you to measure the load applied to the rotating shaft. With the help of this model, the tension of the material, which is wound on the shaft during the measurement process, is measured and adjusted.
The moisture- and dust-proof housing with IP55 degree of protection is made of special metal and has anti-corrosion coatings. The convenience of mounting the strain gauge is ensured by the built-in bearing.
| Rated load (Emax) | kg | 100 |
| Accuracy class (OIML R 60) | ||
| Discreteness by class ( n LC ) | ||
| Minimum weighing interval (V min ) | ||
| A common mistake | % Emax | ≤ ± 0.05 |
| Error of return to zero (DR) | % Emax | |
| Minimum load | % Emax | 0 |
| Maximum overload | % Emax | 150 |
| Permissible horizontal overload | % Emax | |
| Destructive overload | % Emax | 300 |
| Deformation (at Emax) | mm | |
| Maximum excitation voltage (Umax) | IN | 15 |
| RCP (Cn) | mV / V | 2 |
| Zero balance | % Cn | ≤ ± 2.0 |
| Input impedance | Ω | 385 ± 20 |
| Output resistance | Ω | 350 ± 3 |
| Insulation resistance | MΩ | ≥500 |
| Compensated operating range | ° С | -10 … + 40 |
| Operating temperature range | ° С | -40 … + 80 |
| Sensor material | steel | |
| Protection class (according to EN60529 classification) | IP55 | |
| Cable length | m | 5 |
| Cable diameter | mm | 5 |
| Mass | kg | 1.3 |
| Package weight and dimensions | cm / kg | 14.5 x 23 x 6 / 1.5 |
Reviews
There are no reviews yet.