Tensometric sensor DSB 15 t (Special developments)
Among cantilever shear beams with two load points, it is worth noting the strain gauge of the DSB model. With vertical overloads and lateral loads, the DSB sensor copes quite successfully thanks to the reliable design of the housing.
In addition, the body of the sensor is protected against moisture and dust, has a degree of protection IP68, as well as an anti-corrosion coating. With the help of a welded cover made of stainless steel, the strain gauge area is protected.
The DSB sensor model is used in portable scales that measure axle loads of motor vehicles, in vehicle weighing systems, and in tank weighing systems.
| Rated load (Emax) | kg | 15000 |
| Accuracy class (OIML R 60) | ||
| Discreteness by class ( n LC ) | ||
| Minimum weighing interval (V min ) | ||
| A common mistake | % Emax | ≤ ± 0.3 |
| Error of return to zero (DR) | % Emax | |
| Minimum load | % Emax | 0 |
| Maximum overload | % Emax | 200 |
| Permissible horizontal overload | % Emax | |
| Destructive overload | % Emax | 100 |
| Deformation (at Emax) | mm | |
| Maximum excitation voltage (Umax) | IN | |
| RCP (Cn) | mV / V | 2 |
| Zero balance | % Cn | ≤ ± 2.0 |
| Input impedance | Ω | 210 |
| Output resistance | Ω | 180 |
| Insulation resistance | MΩ | ≥500 |
| Compensated operating range | ° С | -10 … + 40 |
| Operating temperature range | ° С | -40 … + 80 |
| Sensor material | steel | |
| Protection class (according to EN60529 classification) | IP68 | |
| Cable length | m | 8 |
| Cable diameter | mm | 6 |
| Mass | kg | 7.6 |
| Package weight and dimensions | cm / kg | 32x34x15 / 8 |
Reviews
There are no reviews yet.